ZyXEL Communications XGS-4528F - Two Subnets Example; Figure 158 VRRP Example 1: VRRP Parameter Settings on Switch a; Figure 159 VRRP Example 1: VRRP Parameter Settings on Switch B; Figure 160 VRRP Example 1: VRRP Status on Switch a

Chapter 33 VRRP
XGS-4528F User’s Guide
273
You want to set switch A as the master router. Configure the VRRP parameters in the VRRP
Configuration screens on the switches as shown in the figures below.
Figure 158 VRRP Example 1: VRRP Parameter Settings on Switch A
Figure 159 VRRP Example 1: VRRP Parameter Settings on Switch B
After configuring and saving the VRRP configuration, the VRRP Status screens for both
switches are shown next.
Figure 160 VRRP Example 1: VRRP Status on Switch A
Figure 161 VRRP Example 1: VRRP Status on Switch B
33.4.2 Two Subnets Example
The following figure depicts an example in which two switches share the network traffic.
Hosts in the two network groups use different default gateways. Each switch is configured to
backup a virtual router using VRRP.
You wish to configure switch A as the master router for virtual router VR1 and as a backup for
virtual router VR2. On the other hand, switch B is the master for VR2 and a backup for VR1.
EXAMPLE
EXAMPLE
EXAMPLE
EXAMPLE