ZyXEL Communications XGS-4528F - Figure 162 VRRP Configuration Example: Two Virtual Router Network; Figure 163 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch a; Figure 164 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch B

Chapter 33 VRRP
XGS-4528F User’s Guide
274
Figure 162 VRRP Configuration Example: Two Virtual Router Network
You need to configure the VRRP Configuration screen for virtual router VR2 on each
switch, while keeping the VRRP configuration in example 1 for virtual router VR1 (refer to
Section 33.4.2 on page 273). Configure the VRRP parameters on the switches as shown in the
figures below.
Figure 163 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch A
Figure 164 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch B
After configuring and saving the VRRP configuration, the VRRP Status screens for both
switches are shown next.
172.21.1.1
172.21.1.10
172.21.1.100
EXAMPLE
EXAMPLE