XGS1210-12 User’s Guide
13
CHAPTER 2
Hardware Installation
2.1 Installation Scenarios
This chapter shows you how to install and connect the Switch.
2.1.1 Desktop Installation Procedure
1 Make sure the Switch is clean and dry.
2 Attach the rubber feet as shown if they are not already attached - see Figure 5 on page 13.
3 Set the Switch on a smooth, level surface strong enough to support the weight of the Switch and the
connected cables. Make sure there is a power outlet nearby.
4 Make sure there is enough space around the Switch to allow the attachment of cables and the power
cord, and sufficient air circulation.
Note: Make sure you are using the correct type of Ethernet cable (Category 5e, 6UTP/STP, or
better Ethernet cable). See Table 1 on page 10 for more information.
Figure 5 Attach Rubber Feet
2.1.2 Wall Mounting
Do the following to mount your Switch on a wall.
Table 2 Wall Mounting Distance
DISTANCE ‘D’ BETWEEN MOUNTING HOLES
180 mm / 7.09 in
To Next Page
Loading...
