XGS1210-12 User’s Guide
14
1 Drill two holes on the wall at the distance of ‘D’ - see Figure 6 on page 14.
2 Insert screw anchors and screws (not provided) into the holes. Leave a small gap between the head of
the screw and the wall.
3 The gap must be big enough for the screws to slide into the wall mount holes and the power cord to run
down the back of the Switch.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the Switch with the connection cables.
4 Place the Switch so the wall mount holes line up with the screws. Slide the Switch down gently to fix it into
place.
Wall-mount the Switch with the Ethernet ports facing down and the
ventilation holes on the side.
Figure 6 Wall Mounting
Figure 7 Screw Specifications
To Next Page
Loading...
