XGS1210-12 User’s Guide
53
Figure 31 Switch Management
The following table describes the labels in this screen.
Table 14 Switch Management
LABEL DESCRIPTION
Device Setting
Reset Click this button to clear all Switch configuration information you configured and return to the
factory defaults.
If you want to access the Switch Web Configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address
(192.168.1.3).
Reboot Click this button to restart the Switch without physically turning the power off.
Firmware
upgrade
Click this button to upgrade the Switch to the latest firmware.
DHCP Client Select Enable if you have a DHCP server that can assign the Switch an IP address, subnet mask,
a default gateway IP address and a domain name server IP address automatically. Otherwise,
select Disable.
IP Address Enter the IP address of your Switch in dotted decimal notation, for example, 192.168.1.3. This is
the IP address of the Switch in an IP routing domain.
Subnet Mask Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
255.255.255.0.
Gateway Type the IP address of the default outgoing gateway in dotted decimal notation, for example,
192.168.1.254.
Apply Click this button to save your changes to the Switch.
IEEE 802.3az EEE Select Enable to activate Energy Efficient Ethernet globally. Otherwise, select Disable.
To Next Page
Loading...
