Chapter 12 QoS
XGS1210-12 / XGS1250-12 User’s Guide
55
The Switch’s default settings for IEEE 802.1p QoS are shown in the next figure. The numbers from 0 to 7
refer to the priority tags for each traffic type. Refer to Table 15 on page 53.
Figure 40 QoS > IEEE 802.1p QoS
The following table describes the labels in this screen.
Table 17 QoS > IEEE 802.1p QoS
LABEL DESCRIPTION
IEEE 802.1p QoS
Priority 0 – 7 Select which priority tags will carry the sensitive data, using the priority queuing levels given.
Click each priority tag’s radio button to assign a priority queue.
Weight Assign the weight (the number you select in the queue Weight field) to each priority.
Remember the weight is based on WRR Scheduling, explained in Section 12.2.3 on page 53.
Bandwidth is divided across the different traffic queues according to their weights. Queues with
larger weights get more service than queues with smaller weights.
Apply Click Apply to save your changes to the Switch.
To Next Page
Loading...
