Stacking Support Note
All contents copyright (c) 2012 ZyXEL Communications Corporation.
Configuration Guide
In total, we need to configure three switches in this scenario. Configuration will start
from XGS1910-48_1F to XGS1910-24_1F and XGS1910-24_24F.
Goals to achieve:
1) The XGS1910-48_1F will be a master switch.
2) A server will use LACP to connect with XGS1910-24_1F and
XGS1910-48_1F.
1.1 XGS1910-48_1F Configuration steps:
Step 1 : Monitor > System > Information to check the firmware version.
Step 2 : Configuration > System > IP to configure an IP address on the switch.
To Next Page
Loading...
