Chapter 5 Tutorials
GS1910/XGS1910 Series User’s Guide
41
5.5 How to Set Up a Guest VLAN with IEEE 802.1x
Authentication
All ports on the Switch are in VLAN 1 by default. Say you enable IEEE 802.1x authentication on
ports 1 to 8. Clients that connect to these ports should provide the correct user name and password
in order to access the ports. You want to assign clients that connect to ports 1, 2 or 3 to a guest
VLAN (200 for example) when they fail to authenticate with the authentication server. In this guest
VLAN, clients can surf the Internet through a gateway attached to port 10, but are not allowed to
access other network resources, such as the mail server or local data base.
5.5.1 Creating a VLAN for Port which is not IEEE 802.1x enabled
Follow the steps below to configure port 10 as a member of VLAN 200.
1 Access the web configurator through the Switch’s port which is not in VLAN 200.
2 Click Configuration > VLANs > VLAN Membership in the navigation panel. Click Add New
VLAN to create VLAN2.
3 Enter 200 in the VLAN ID field and enter a descriptive name (VLAN200 for example) in the VLAN
Name field for this VLAN.
4 Configure port 10 to be a permanent member of the VLAN.
Internet
Guest VLAN 200
Ports 1, 2, 3 and 10
VLAN 1
To Next Page
Loading...
