Chapter 5 Tutorials
GS1910/XGS1910 Series User’s Guide
57
9 Go to Configuration > MAC Table to disable MAC address learning on the reflector and
intermediate ports so that the Switch will NOT filter or forward a frame based on the frame’s
destination MAC address, or even drop the frame whose MAC address is not in the MAC address
table on these ports.
In Switch B:
1 Access the Switch through http://192.168.1.1. Log into the Switch by entering the username
(default: admin) and password (default: 1234).
2 Go to Configuration > Port Mirroring. Select Enabled in the Mode field to activate mirroring on
the Switch.
3 Set Type to Intermediate to configure the intermediate ports that help forward traffic.
4 Enter the remote port mirroring VLAN ID number (100 in this example). The Switch will
automatically create the remote port mirroring VLAN and configure the intermediate ports as a
member of this VLAN.
5 Configure ports (3 and 4 for example) to act as the intermediate ports that connect to Switch A and
Switch C.
To Next Page
Loading...
