ZyXEL Communications XGS2220 Series - Add;Edit LLDP-MED Network Policy

Chapter 35 Link Layer Discovery Protocol (LLDP)
XGS2220 Series User’s Guide
244
35.9.1 Add/Edit LLDP-MED Network Policy
To access this screen, click the Add/Edit button or select an entry from the list and click the Add/Edit
button.
Figure 175 PORT > LLDP > LLDP MED > LLDP-MED Network Policy > Add/Edit
The following table describes the labels in this screen.
Add/Edit Click Add/Edit to add a new schedule rule or edit a selected one.
Delete Select the rules that you want to remove, then click Delete.
Table 117 PORT > LLDP > LLDP MED > LLDP-MED Network Policy (continued)
LABEL DESCRIPTION
Table 118 PORT > LLDP > LLDP MED > LLDP-MED Network Policy > Add/Edit
LABEL DESCRIPTION
Port Enter the port number to set up the LLDP-MED network policy. You can enter multiple ports
separated by (no space) comma (“,”) or hyphen (“-”) for a range. For example, enter “3-5”
for ports 3, 4, and 5. Enter “3,5,7” for ports 3, 5, and 7.
Application Type Select the type of application used in the network policy.
• voice
• voice-signaling
•guest-voice
• guest-voice-signaling
• softphone-voice
• video-conferencing
• streaming-video
• video-signaling
Tag Select to tag or untag in the network policy.
•tagged
• untagged
VLAN Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter “0”.
DSCP Enter the DSCP value of the network policy. The value is defined from 0 through 63 with the 0
representing use of the default DSCP value.
Priority Enter the priority value for the network policy.