ZyXEL Communications XGS2220 Series - 52.3 sFlow Collector Configuration

Chapter 52 sFlow
XGS2220 Series User’s Guide
336
52.3 sFlow Collector Configuration
Click SWITHCING > sFlow > Collector to display the screen as shown. You may want to configure more
than one collector if the traffic load to be monitored is more than one collector can manage.
Note: You can configure up to four sFlow collectors in this screen.
Figure 245 SWITHCING > sFlow > Collector
The following table describes the labels in this screen.
52.3.1 Add/Edit sFlow Collector
Click Add/Edit, or select an entry and click Add/Edit in the SWITHCING > sFlow > Collector screen to
display this screen.
Figure 246 SWITCHING > sFlow > Collector > Add/Edit
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 175 SWITCHING > sFlow (continued)
LABEL DESCRIPTION
Table 176 SWITHCING > sFlow > Collector
LABEL DESCRIPTION
Index This field displays the index number of this entry.
Collector
Address
This field displays IP address of the sFlow collector.
UDP Port This field displays port number the Switch uses to send sFlow datagram to the collector.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Add/Edit Click Add/Edit to add a new entry or edit a selected one.
Delete Click Delete to remove the selected entries.