ZyXEL Communications XGS3700 Series - One Subnet Network Example

Chapter 38 VRRP
GS3700/XGS3700 Series User’s Guide
319
38.4.1 One Subnet Network Example
The figure below shows a simple VRRP network with only one virtual router VR1 (VRID =1) and two
switches. The network is connected to the WAN via an uplink gateway G (172.16.1.100). The host
computer X is set to use VR1 as the default gateway.
Figure 205 VRRP Configuration Example: One Virtual Router Network
You want to set switch A as the master router. Configure the VRRP parameters in the VRRP
Configuration screens on the switches as shown in the figures below.
Figure 206 VRRP Example 1: VRRP Parameter Settings on Switch A
Figure 207 VRRP Example 1: VRRP Parameter Settings on Switch B
172.16.1.100
172.16.1.1
172.16.1.10
EXAMPLE
EXAMPLE