ZyXEL Communications XGS4600 Series - Ipv6 Global Setup; Ipv6 Interface Setup

Chapter 8 Basic Setting
XGS4600 Series User’s Guide
104
8.9.4 IPv6 Global Setup
Use this screen to configure the global IPv6 settings. Click the link next to IPv6 Global Setup in the IPv6
Configuration screen to display the screen as shown next.
Figure 79 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
The following table describes the labels in this screen.
8.9.5 IPv6 Interface Setup
Use this screen to turn on or off an IPv6 interface. Click the link next to IPv6 Interface Setup in the IPv6
Configuration screen to display the screen as shown next.
IPv6 Neighbor Setup Click the link to go to a screen where you can create a static IPv6 neighbor entry in the
Switch’s IPv6 neighbor table.
DHCPv6 Client Setup Click the link to go to a screen where you can configure the Switch DHCPv6 client settings.
Table 26 Basic Setting > IPv6 > IPv6 Configuration (continued)
LABEL DESCRIPTION
Table 27 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Setup
LABEL DESCRIPTION
IPv6 Hop Limit Specify the maximum number of hops (from 1 to 255) in router advertisements. This is the
maximum number of hops on which an IPv6 packet is allowed to transmit before it is discarded by
an IPv6 router, which is similar to the TTL field in IPv4.
ICMPv6 Rate
Limit Bucket
Size
Specify the maximum number of ICMPv6 error messages (from 1 to 200) which are allowed to
transmit in a given time interval. If the bucket is full, subsequent error messages are suppressed.
ICMPv6 Rate
Limit Error
Interval
Specify the time period (from 0 to 2147483647 milliseconds) during which ICMPv6 error messages
of up to the bucket size can be transmitted. 0 means no limit.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to the factory defaults.