ZyXEL Communications XGS4600 Series - Page 176

Chapter 13 Spanning Tree Protocol
XGS4600 Series User’s Guide
176
Note: This screen is only available after you activate MRSTP on the Switch.
Figure 140 Advanced Application > Spanning Tree Protocol (Standalone Mode)
Figure 141 Advanced Application > Spanning Tree Protocol (Stacking Mode)
The following table describes the labels in this screen.
Table 66 Advanced Application > Spanning Tree Protocol
LABEL DESCRIPTION
Configuration Click Configuration to specify which STP mode you want to activate. Click MRSTP to edit
MRSTP settings on the Switch.
Tree Select which STP tree configuration you want to view.
Bridge Root refers to the base of the spanning tree (the root bridge). Our Bridge is this switch. This
Switch may also be the root bridge.
Bridge ID This is the unique identifier for this bridge, consisting of bridge priority plus MAC address. This ID
is the same for Root and Our Bridge if the Switch is the root switch.
Hello Time
(second)
This is the time interval (in seconds) at which the root switch transmits a configuration
message. The root bridge determines Hello Time, Max Age and Forwarding Delay.
Max Age (second) This is the maximum time (in seconds) the Switch can wait without receiving a configuration
message before attempting to reconfigure.