Chapter 16 Mirroring
XGS4600 Series User’s Guide
191
16.1.1 Remote Port Mirroring
Use this screen to create a remote port mirroring (RMirror) VLAN through which the mirrored traffic is
forwarded.
Note: Your Switch automatically creates a static VLAN (with the same VID) when you create
a RMirror VLAN in this screen.
Click the RMirror link in the Advanced Application > Mirroring screen. The following screen opens.
Figure 152 Advanced Application > Mirroring > RMirror
The following table describes the labels in this screen.
16.1.2 Source
Use this screen to configure the reflector port and specify the traffic flow to be copied to the monitor
port when the Switch is the source device in remote port mirroring.
Click the Source link in the RMirror screen. The following screen opens.
Table 70 Advanced Application > Mirroring > RMirror
LABEL DESCRIPTION
Active Select the option to enable the VLAN.
RMirror VLAN ID Specify the ID number of remote port mirroring (RMirror) VLAN.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VLAN This field displays the ID number of the RMirror VLAN. Click on the VLAN ID number to change
the settings.
Active This field displays whether the VLAN is enabled or not.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Check the rules that you want to remove and then click the Delete button.
Cancel Click Cancel to clear the selected check boxes.
To Next Page
Loading...
