ZyXEL Communications XGS4600 Series - Page 194

Chapter 16 Mirroring
XGS4600 Series User’s Guide
194
Figure 155 Advanced Application > Mirroring > RMirror > Destination (Standalone Mode)
Figure 156 Advanced Application > Mirroring > RMirror > Destination (Stacking Mode)
The following table describes the labels in this screen.
Table 72 Advanced Application > Mirroring > RMirror > Destination
LABEL DESCRIPTION
RMirror VLAN ID Select the RMirror VLAN over which the mirrored traffic is forwarded.
Monitor Port Specify the port to which you copy the traffic in order to examine it in more detail without
interfering with the traffic flow on the original ports.
In stacking mode, the first box field is the slot ID and the second field is the port number.
Tagging Select whether to add the RMirror VLAN tag to mirrored traffic on the monitor port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VLAN This field displays the ID number of RMirror VLAN over which the mirrored traffic is
forwarded.
Monitor Port This field displays the number of port that receives the mirrored traffic from the source
device for analysis.
Tagging This field displays whether the mirrored traffic is tagged with the RMirror VLAN ID.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Delete Check the rules that you want to remove in the Delete column and then click the Delete
button.
Cancel Click Cancel to begin configuring this screen afresh.