ZyXEL Communications XGS4600 Series - Page 205

Chapter 17 Link Aggregation
XGS4600 Series User’s Guide
205
Figure 163 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP (Stacking
Mode)
The following table describes the labels in this screen.
Table 78 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do NOT configure this screen unless you want to enable dynamic link
aggregation.
Active Select this check box to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP “server”. The LACP
“server” controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
LACP Active Select this option to enable LACP for a trunk.
SLOT This field appears only in stacking mode. Click the drop-down list to choose the slot number of the
Switch in a stack.