Chapter 25 Multicast
XGS4600 Series User’s Guide
268
25.4 IPv6 Multicast Status
Click Advanced Application > Multicast > IPv6 Multicast to display the screen as shown. This screen
shows the IPv6 multicast group information. See Section 25.1 on page 257 for more information on
multicasting.
Figure 207 Advanced Application > Multicast > IPv6 Multicast
The following table describes the fields in the above screen.
25.4.1 MLD Snooping-proxy
Click the MLD Snooping-proxy link in the Advanced Application > Multicast > IPv6 Multicast screen to
display the screen as shown. See Section 25.1 on page 257 for more information on multicasting.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear Click Clear to reset the fields to the factory defaults.
Profile Name This field displays the descriptive name of the profile.
Start Address This field displays the start of the multicast address range.
End Address This field displays the end of the multicast address range.
Delete Profile Select a profile’s check box to select a specific profile. Otherwise, select the check box in the
table heading row to select all profiles.
Delete Rule Select the check boxes of the rules that you want to remove from a profile.
Delete To delete the profiles and all the accompanying rules, select the profiles that you want to
remove in the Delete Profile column, then click the Delete button.
To delete a rules from a profile, select the rules that you want to remove in the Delete Rule
column, then click the Delete button.
Cancel Click Cancel to clear the Delete Profile or Delete Rule check boxes.
Table 104 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering Profile
LABEL DESCRIPTION
Table 105 Advanced Application > Multicast > IPv6 Multicast
LABEL DESCRIPTION
Index This is the index number of the entry.
VID This field displays the multicast VLAN ID.
Port This field displays the port number that belongs to the multicast group. In stacking mode,
the first number represents the slot and the second is the port number.
Multicast Group This field displays IP multicast group addresses.
Group Timeout This field displays the time (in seconds) that elapses before the Switch removes a MLD group
membership entry if it does not receive report messages from the port.
To Next Page
Loading...
