ZyXEL Communications XGS4600 Series - Page 274

Chapter 25 Multicast
XGS4600 Series User’s Guide
274
Figure 213 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
(Stacking Mode)
The following table describes the fields in the above screen.
Table 109 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
LABEL DESCRIPTION
Active Select this option to enable MLD filtering on the Switch.
SLOT This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
Port This field displays the port number. In stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last two
ports of your Switch) cannot be configured. They are reserved for stacking only.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Group Limit Select this option to limit the number of multicast groups this port is allowed to join.
Max Group Num. Enter the number of multicast groups this port is allowed to join. Once a port is registered in
the specified number of multicast groups, any new MLD Report message is dropped on this
port.
Filtering Profile Select the name of the MLD filtering profile to use for this port. Otherwise, select Default to
prohibit the port from joining any multicast group.
You can create MLD filtering profiles in the Multicast > IPv6 Multicast > MLD Snooping-proxy
> Filtering > Filtering Profile screen.