ZyXEL Communications XGS4600 Series - Page 321

Chapter 29 ARP Inspection
XGS4600 Series User’s Guide
321
Figure 247 Advanced Application > IP Source Guard > IPv6 Static Binding Setup (Stacking Mode)
The following table describes the labels in this screen.
Table 137 Advanced Application > IP Source Guard > IPv6 Static Binding Setup
LABEL DESCRIPTION
IPv6 Static Binding
Source Address Enter the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address Enter the source MAC address in the binding. If this binding does not check this field, select
Any.
Note: You cannot choose Any for all three of MAC Address, VLAN and Port. You
must fill in at least one.
VLAN Enter the source VLAN ID in the binding. If this binding does not check this field, select Any.
Port Specify the ports in the binding. If this binding has one port, select the first radio button and
enter the port number in the field to the right. In stacking mode, the first field is the slot ID and
the second field is the port number. If this binding applies to all ports, select Any.
Add Click this to create the specified static binding or to update an existing one.
Cancel Click this to reset the values above based or if not applicable, to clear the fields above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each binding.
Source Address This field displays the IPv6 address or IPv6 prefix and prefix length in the binding.
MAC Address This field displays the source MAC address in the binding. If the entry is blank, this field will not
be checked in the binding.
VLAN This field displays the source VLAN ID in the binding. If the entry is blank, this field will not be
checked in the binding.
Port This field displays the port number in the binding. If this field is blank, the binding applies to all
ports. In stacking mode, the first number represents the slot and the second the port number
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Select an entry check box and click Delete to remove the specified entry.
Cancel Click this to clear the Delete check boxes above.