Chapter 34 PPPoE
XGS4600 Series User’s Guide
353
34.3.2 PPPoE IA Per-Port Per-VLAN
Use this screen to configure PPPoE IA settings that apply to a specific VLAN on a port.
Click the VLAN link in the Intermediate Agent > Port screen to display the screen as shown.
Figure 279 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN (Standalone Mode)
Figure 280 Advanced Application > PPPoE > Intermediate Agent > Port > VLAN (Stacking Mode)
Remote-id Enter a string of up to 63 ASCII characters that the Switch adds into the Agent Remote ID sub-
option for PPPoE discovery packets received on this port. Spaces are allowed.
If you do not specify a string here or in the Remote-id field for a VLAN on a port, the Switch
automatically uses the PPPoE client’s MAC address.
The Remote ID you configure for a specific VLAN on a port (in the Advanced Application >
PPPoE > Intermediate Agent > Port > VLAN screen) has the highest priority.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 155 Advanced Application > PPPoE > Intermediate Agent > Port (continued)
LABEL DESCRIPTION
To Next Page
Loading...
