Chapter 3 Hardware Panels
XGS4600 Series User’s Guide
38
Figure 17 Transceiver Removal Example
3.1.3 Dual Personality Interfaces
There are four Dual Personality interfaces, comprising four 1000Base-T / SFP combo ports. For each
interface you can connect either to the 1000Base-T port or the SFP port. The SFP ports have priority over
the 1000Base-T ports. This means that if a SFP port and the corresponding 1000Base-T port are
connected at the same time, the 1000Base-T port will be disabled.
3.1.4 Management Port
The 1000Base-T Ethernet MGMT (management) port is used for local management. Connect directly to
this port using an Ethernet cable. You can configure the Switch through Telnet or the Web Configurator.
The default IP address of the management port is 192.168.0.1 with a subnet mask of 255.255.255.0.
3.1.5 Console Port
This console port is for troubleshooting only. With instructions from customer support, connect the male 9-
pin end of the RS-232 console cable to the console port of the Switch. Connect the female end to a
serial port (COM1, COM2 or other COM port) of your computer. You can use a computer with terminal
emulation software configured to the following parameters:
• VT100 terminal emulation
• 115200 bps
• No parity, 8 data bits, 1 stop bit
• No flow control
3.2 Rear Panel
The following figures show the rear panels of the Switch. The rear panels contain:
• Two power modules with power receptacles (A and B)
• XGS4600-52F: A console port for configuring the Switch using the command line interface
Figure 18 Rear Panel: XGS4600-32
To Next Page
Loading...
