ZyXEL Communications XGS4600 Series - Page 394

Chapter 40 Link Layer Discovery Protocol (LLDP)
XGS4600 Series User’s Guide
394
Figure 313 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting (Standalone
Mode)
Figure 314 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting (Stacking
Mode)
The following table describes the labels in this screen.
Table 178 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL DESCRIPTION
SLOT This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
Port This field displays the port number. In stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last two
ports of your Switch) cannot be configured. They are reserved for stacking only.
* Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Dot1 TLV
Port-Protocol
VLAN ID
Select the check boxes to enable or disable the sending of IEEE 802.1 Port and Protocol VLAN
ID TLVs on the ports.
Port VLAN ID Select the check boxes to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the ports. All check boxes in this column are enabled by default.