Chapter 40 Link Layer Discovery Protocol (LLDP)
XGS4600 Series User’s Guide
395
40.7 LLDP-MED Configuration
Click Advanced Application > LLDP > LLDP-MED Configuration to display the screen as shown next.
Figure 315 Advanced Application > LLDP > LLDP-MED Configuration (Standalone Mode)
Link
Aggregation
Select the check boxes to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the ports.
Dot3 TLV
MAC/PHY Select the check boxes to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the ports. All check boxes in this column are enabled by default.
Max Frame Size Select the check boxes to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs on
the ports.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 178 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting (continued)
LABEL DESCRIPTION
To Next Page
Loading...
