Chapter 49 RIP
XGS4600 Series User’s Guide
444
Click IP Application > RIP in the navigation panel to display the screen as shown.
Click the link next to IPv4 RIP to open a screen where you can enable RIP for IPv4 and configure the RIP
version and direction for an IP interface.
Click the link next to IPv6 RIP to open a screen where you can enable RIP for IPv6 (RIPng) and configure
the RIP timers and method of preventing routing loops for an IPv6 VLAN interface.
Figure 353 IP Application > RIP
49.2 Configuring IPv4 RIP
Click IP Application > RIP > IPv4 RIP in the navigation panel to display the screen as shown. You cannot
manually configure a new entry. Each entry in the table is automatically created when you configure a
new IP domain in the IP Setup screen.
Figure 354 IP Application > RIP > IPv4 RIP
Table 201 Default Distance Value
ROUTE SOURCE ADMINISTRATIVE DISTANCE
Local 0
Static 1
OSPF 110
RIP 120
To Next Page
Loading...
