Chapter 49 RIP
XGS4600 Series User’s Guide
445
The following table describes the labels in this screen.
Table 202 IP Application > RIP > IPv4 RIP
LABEL DESCRIPTION
Active Select this check box to enable IPv4 RIP on the Switch.
Distance Enter a number from 10 to 255 to specify the administrative distance that is assigned to routes
learned by RIP.
The lower the administrative distance value is, the more preferable the routing protocol is.
Note: You cannot set two routing protocols to have the same administrative distance.
Index This field displays the index number of an IP interface.
* Settings in this row apply to all entries.
Use this row only if you want to make some settings the same for all entries. Use this row first to set the
common settings and then make adjustments on a per entry basis.
Note: Changes in this row are copied to all the entries as soon as you make them.
Network This field displays the IP interface configured on the Switch.
Refer to the section on IP Setup for more information on configuring IP domains.
Direction Select the RIP direction from the drop-down list box. Choices are Outgoing, Incoming, Both and
None.
Version Select the RIP version from the drop-down list box. Choices are RIP-1, RIP-2B and RIP-2M.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
