Chapter 50 OSPF
XGS4600 Series User’s Guide
465
50.11 IPv6 OSPF Redistribution
Use this screen to configure route redistribution. Route redistribution is used when other routers which use
RIP routing protocol and/or static routes need to exchange routing information with the Switch using
OSPF routing protocol.
In the IPv6 OSPF Configuration screen, click Redistribute to display the OSPF Redistribution screen.
Figure 368 IP Application > OSPF > IPv6 OSPF > Configuration > Redistribute
Stub / NSSA Select this option to set the area as a stub area or a not-so-stubby area.
If you enter 0.0.0.0 in the Area ID field, the settings in the stub area fields are ignored.
No Summary Select this option to set the Switch to not send/receive LSAs.
Default
route cost
Specify a cost (between 0 and 16777215) used to add a default route into a stub area for routes
which are external to an OSPF domain. If you do not set a route cost, no default route is added.
Add Click Add to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to reset the fields to default settings.
Index This field displays the index number of an area.
Area ID This field displays the area ID (that uses the format of an IP address in dotted decimal notation)
that uniquely identifies an area.
An area ID of 0.0.0.0 indicates the backbone.
Stub / NSSA This field displays the area defined (Stub, NSSA or None).
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.
Table 216 IP Application > IPv6 OSPF > Configuration (continued)
LABEL DESCRIPTION
To Next Page
Loading...
