Chapter 54 DHCP
XGS4600 Series User’s Guide
491
54.4.6 DHCPv4 VLAN Setting
Use this screen to configure your DHCP settings based on the VLAN domain of the DHCP clients. Click IP
Application > DHCP > DHCPv4 in the navigation panel, then click the VLAN link In the DHCP Status screen
that displays.
Note: You must set up a management IP address for each VLAN that you want to configure
DHCP settings for on the Switch.
Figure 394 IP Application > DHCP > DHCPv4 > VLAN
The following table describes the labels in this screen.
Table 235 IP Application > DHCP > DHCPv4 > VLAN
LABEL DESCRIPTION
VID Enter the ID number of the VLAN to which these DHCP settings apply.
DHCP Status Select whether the Switch should function as a DHCP Server or Relay for the specified VID. If you
select Server then fields related to DHCP relay configuration are grayed out and vice versa.
Server Use this section if you want to configure the Switch to function as a DHCP server for this VLAN.
Client IP Pool
Starting
Address
Specify the first of the contiguous addresses in the IP address pool.
Size of Client
IP Pool
Specify the size, or count of the IP address pool. The Switch can issue from 1 to 253 IP addresses
to DHCP clients.
IP Subnet
Mask
Enter the subnet mask for the client IP pool.
Default
Gateway
Enter the IP address of the default gateway device.
To Next Page
Loading...
