ZyXEL Communications XGS4600 Series - Page 508

Chapter 55 VRRP
XGS4600 Series User’s Guide
508
Figure 414 VRRP Configuration Example: Two Virtual Router Network
You need to configure the VRRP Configuration screen for virtual router VR2 on each switch, while
keeping the VRRP configuration in example 1 for virtual router VR1 (refer to Section 55.4.2 on page 507).
Configure the VRRP parameters on the switches as shown in the figures below.
Figure 415 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch A
Figure 416 VRRP Example 2: VRRP Parameter Settings for VR2 on Switch B
After configuring and saving the VRRP configuration, the VRRP Status screens for both switches are
shown next.
EXAMPLE
EXAMPLE