Chapter 58 Maintenance
XGS4600 Series User’s Guide
519
Figure 425 Management > Maintenance (Standalone Mode)
Figure 426 Management > Maintenance (Stacking Mode)
The following table describes the labels in this screen.
Table 249 Management > Maintenance
LABEL DESCRIPTION
Firmware
Upgrade
Click Click Here to go to the Firmware Upgrade screen.
Restore
Configuration
Click Click Here to go to the Restore Configuration screen.
Backup
Configuration
Click Click Here to go to the Backup Configuration screen.
Auto
Configuration
Click Click Here to go to the Auto Configuration screen.
Erase Running-
Configuration
Click Click Here to reset the configuration to the Zyxel default configuration settings. Note that
this will not reset the configuration to the factory default settings.
Save
Configuration
Click Config 1 to save the current configuration settings to Configuration 1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch.
Click Custom Default to save the current configuration settings to a customized default file on
the Switch. This file can be used instead of the Zyxel factory default configuration file.
To Next Page
Loading...
