Chapter 4 Web Configurator
XGS4600 Series User’s Guide
52
4.4 Web Configurator Layout
The Status screen is the first screen that displays when you access the Web Configurator.
This guide uses the XGS4600-32F and XGS4600-52F screens as examples. The screens may vary slightly for
different models.
The following figure shows the navigating components of a Web Configurator screen.
IP Address This field displays the IP address of an internal interface on the discovered device that
first received a ZDP discovery request from the ZON Utility.
System Name This field displays the system name of the discovered device.
Location This field displays where the discovered device is.
Status This field displays whether changes to the discovered device have been done
successfully. As the Switch does not support IP Configuration, Renew IP address and
Flash Locator LED, this field displays “Update failed”, “Not support Renew IP address”
and “Not support Flash Locator LED” respectively.
Controller Discovery This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it is enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it will go
into the Nebula cloud management mode.
Serial Number Enter the admin password of the discovered device to display its serial number.
Hardware Version This field displays the hardware version of the discovered device.
Table 7 ZON Utility Fields (continued)
LABEL DESCRIPTION
To Next Page
Loading...
