ZyXEL Communications XGS4600 Series - Set up Login Accounts

Chapter 59 Access Control
XGS4600 Series User’s Guide
542
59.4 Set Up Login Accounts
Up to five people (one administrator and four non-administrators) may access the Switch through Web
Configurator at any one time.
• An administrator is someone who can both view and configure Switch changes. The user name for
the Administrator is always admin. The default administrator password is 1234.
Note: It is highly recommended that you change the default administrator password (1234).
• A non-administrator (user name is something other than admin) is someone who can view and/or
configure Switch settings. The configuration right varies depending on the user’s privilege level.
Click Management > Access Control > Logins to view the screen as shown.
Figure 446 Management > Access Control > Logins
The following table describes the labels in this screen.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to begin configuring this screen afresh.
Table 261 Management > Access Control > SNMP > User (continued)
LABEL DESCRIPTION
Table 262 Management > Access Control > Logins
LABEL DESCRIPTION
Administrator
This is the default administrator account with the “admin” user name. You cannot change the default administrator
user name.
Old Password Type the existing system password (1234 is the default password when shipped).
New Password Enter your new system password.
Retype to
confirm
Retype your new system password for confirmation.