Chapter 4 Web Configurator
XGS4600 Series User’s Guide
55
Port Setup This link takes you to screens where you can configure speed, flow control and priority settings
for individual Switch ports.
Interface Setup This link takes you to a screen where you can create virtual interfaces on the Switch.
IPv6 This link takes you to a screen where you can enable an IPv6 interface and configure the IPv6
settings on the Switch.
Loopback
Interface
This link takes you to a screen where you can configure the IPv4 loopback interface settings
on the Switch.
Stacking This link takes you to a screen where you can view and configure stacking system for the
Switch.
Advanced Application
VLAN This link takes you to screens where you can configure port-based or 802.1Q VLAN
(depending on what you configured in the Switch Setup menu). You can also configure a
protocol based VLAN or a subnet based VLAN in these screens.
Static MAC
Forwarding
This link takes you to screens where you can configure static MAC addresses for a port. These
static MAC addresses do not age out.
Static Multicast
Forwarding
This link takes you to a screen where you can configure static multicast MAC addresses for
ports. These static multicast MAC addresses do not age out.
Filtering This link takes you to a screen to set up filtering rules.
Spanning Tree
Protocol
This link takes you to screens where you can configure the RSTP/MRSTP/MSTP to prevent
network loops.
Bandwidth Control This link takes you to screens where you can cap the maximum bandwidth allowed on a port.
Broadcast Storm
Control
This link takes you to a screen to set up broadcast filters.
Mirroring This link takes you to screens where you can copy traffic from one port or ports to another port
in order that you can examine the traffic from the first port without interference.
Link Aggregation This link takes you to a screen where you can logically aggregate physical links to form one
logical, higher-bandwidth link.
Port Authentication This link takes you to a screen where you can configure IEEE 802.1x port authentication as well
as MAC authentication for clients communicating through the Switch.
Port Security This link takes you to a screen where you can activate MAC address learning and set the
maximum number of MAC addresses to learn on a port.
Time Range This link takes you to a screen where you can configure time range for time-oriented features
like Classifier.
Classifier This link takes you to screens where you can configure the Switch to group packets based on
the specified criteria.
Policy Rule This link takes you to a screen where you can configure the Switch to perform special
treatment on the grouped packets.
Queuing Method This link takes you to a screen where you can configure queuing with associated queue
weights for each port.
VLAN Stacking This link takes you to screens where you can activate and configure VLAN stacking.
Multicast This link takes you to screens where you can configure various multicast features, IGMP
snooping, MLD snooping-proxy and create multicast VLANs.
AAA This link takes you to a screen where you can configure authentication, authorization and
accounting services through external servers. The external servers can be either RADIUS
(Remote Authentication Dial-In User Service) or TACACS+ (Terminal Access Controller Access-
Control System Plus).
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized DHCP and ARP
packets in your network.
Table 9 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
