Chapter 4 Web Configurator
XGS4600 Series User’s Guide
57
4.4.1 Change Your Password
After you log in for the first time, it is recommended you change the default administrator password.
Click Management > Access Control > Logins to display the next screen.
DHCP This link takes you to screens where you can configure the DHCP settings.
VRRP This link takes you to screens where you can configure redundant virtual router for your
network.
Router Setup This link takes you to a screen where you can enable Equal-Cost MultiPath (ECMP) routing
and set the criteria the Switch uses to determine the routing path for a packet.
ARP Setup This link takes you to a screen where you can configure ARP learning mode on a per-port
basis and create static ARP entries which do not age out.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration file
maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password and configure
SNMP and remote management.
Diagnostic This link takes you to screens where you can ping IP addresses, run traceroute, test ports.
System Log This link takes you to a screen where you can view system logs.
Syslog Setup This link takes you to a screen where you can setup system logs and a system log server.
Cluster
Management
This link takes you to a screen where you can configure clustering management and view its
status.
MAC Table This link takes you to a screen where you can view the MAC address and VLAN ID of a device
attach to a port. You can also view what kind of MAC address it is.
IP Table This link takes you to a screen where you can view the IP addresses and VLAN ID of a device
attached to a port.You can also view what kind of device it is.
ARP Table This link takes you to a screen where you can view the MAC address – IP address resolution
table.
Routing Table This link takes you to a screen where you can view the routing table.
Path MTU Table This link takes you to a screen where you can view the IPv6 path MTU table.
Configure Clone This link takes you to a screen where you can copy attributes of one port to other ports.
IPv6 Neighbor
Table
This link takes you to a screen where you can view the Switch’s IPv6 neighbor table.
Port Status This link takes you to a screen where you can view the port statistics.
Service Register This link takes you to a screen where you can view the status of your service registrations and
upgrade licenses.
Table 9 Navigation Panel Links (continued)
LINK DESCRIPTION
To Next Page
Loading...
