Chapter 71 Port Status
XGS4600 Series User’s Guide
601
Figure 492 Management > Port Status > Utilization (Stacking Mode)
The following table describes the labels in this screen.
Table 291 Management > Port Status > Utilization
LABEL DESCRIPTION
SLOT This field appears only in stacking mode. Click the drop-down list to choose the slot number of the
Switch in a stack.
Port This identifies the Ethernet port. In stacking mode, the first number represents the slot ID and the
second is the port number.
Link This field displays the speed (such as 100M for 100 Mbps, 1000M for 1000 Mbps, or 10G for 10 Gbps)
and the duplex (F for full duplex). This field displays Down if the port is not connected to any
device.
Tx kB/s This field shows the transmission speed of data sent on this port in kilobytes per second.
Tx Utilization% This field shows the percentage of actual transmitted frames on this port as a percentage of the
Link speed.
Rx KB/s This field shows the transmission speed of data received on this port in kilobytes per second.
Rx Utilization% This field shows the percentage of actual received frames on this port as a percentage of the Link
speed.
To Next Page
Loading...
