ZyXEL Communications XGS4600 Series - Neighbor Screen

Chapter 7 Status
XGS4600 Series User’s Guide
79
7.2.1 Neighbor Screen
The Neighbor screen allows you to view a summary and manage the Switch’s neighboring devices. It
uses Layer Link Discovery Protocol (LLDP) to discover all neighbor devices connected to the Switch
including non-Zyxel devices. You can use this screen to perform tasks on the neighboring devices like
login, power cycle (turn the power off and then back on again), and reset to factory default settings.
This screen shows the neighboring device first recognized on an Ethernet port of the Switch. Device
information is displayed in gray when the neighboring device is offline.
Click Status > Neighbor to see the following screen.
Service Status This field displays the service name (Basic Routing for example) if a service license is enabled at
myZyxel or Not Licensed if the service license is not enabled. It also shows the amount of time
that remains if you enabled a trial license (Basic Routing | Trial 30 day(s) 0 hour(s) for example).
Detail Click this link to go to the Basic Setting > System Info screen to check other detailed information,
such as system resource usage and the Switch temperature, fan speeds or voltage.
IP Address Information
IPv4 Address This field displays the Switch’s current IPv4 address.
Subnet Mask This field displays the Switch’s subnet mask.
Default
Gateway
This field displays the IP address of the Switch’s default gateway.
IP Setup Click the link to go to the Basic Setting > IP Setup screen.
IPV6 Global
Unicast Address
This field displays the Switch’s IPv6 global unicast address
IPV6 Link-Local
Address
This field displays the Switch’s IPv6 link-local address.
IPv6
configuration
Click the link to go to the Basic Setting > IPv6 screen.
Device Status
and Quick
Configuration
This section shows whether a feature is enabled or not on the Switch. You can click a feature’s
Setting link to go to the configuration screen for the feature.
Hover your cursor over a red exclamation mark to display information about the feature.
Quick Links This section provides the shortcut link to a specific configuration screen.
Table 11 Status (continued)
LABEL DESCRIPTION