Chapter 26 SNMP
XMG1930 Series User’s Guide
195
26.4 SNMP Trap Group
Use this screen to specify the types of SNMP traps that should be sent to each SNMP manager. Click
SYSTEM > SNMP > SNMP Trap Group to view the screen as shown.
Figure 129 SYSTEM > SNMP > SNMP Trap Group (Without Access L3 License)
Figure 130 SYSTEM > SNMP > SNMP Trap Group (With Access L3 License)
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Clear Click Clear to clear the fields to the factory defaults.
Cancel Click Cancel to not save the configuration you make and return to the last screen.
Table 83 SYSTEM > SNMP > SNMP User > Add/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
