Chapter 34 Link Aggregation
XMG1930 Series User’s Guide
227
34.3 Link Aggregation Setting
Click PORT > Link Aggregation > Link Aggregation Setting to display the screen shown next. See Section
34.1 on page 224 for more information on link aggregation.
Figure 148 PORT > Link Aggregation > Link Aggregation Setting
The following table describes the labels in this screen.
Table 106 PORT > Link Aggregation > Link Aggregation Setting
LABEL DESCRIPTION
This is the only screen you need to configure to enable static link aggregation.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
Active Select this to activate a trunk group.
To Next Page
Loading...
