Chapter 45 Multicast
XMG1930 Series User’s Guide
305
45.7 MLD Snooping-proxy
Click SWITCHING > Multicast > IPv6 Multicast > MLD Snooping-proxy to display the screen as shown. See
Section 45.1 on page 291 for more information on multicasting.
Figure 204 SWITCHING > Multicast > IPv6 Multicast > MLD Snooping-proxy
The following table describes the fields in the above screen.
45.8 MLD Snooping-proxy VLAN
Click SWITCHING > Multicast > IPv6 Multicast > VLAN screen to display the screen as shown. See Section
45.1 on page 291 for more information on multicasting.
Multicast Group This field displays IP multicast group addresses.
Group Timeout This field displays the time (in seconds) that elapses before the Switch removes a MLD group
membership entry if it does not receive report messages from the port.
Table 145 SWITCHING > Multicast > IPv6 Multicast > IPv6 Multicast Status (continued)
LABEL DESCRIPTION
Table 146 SWITCHING > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL DESCRIPTION
MLD Snooping-proxy
Use these settings to configure MLD snooping-proxy.
Active Enable the switch button to enable MLD snooping-proxy on the Switch to minimize MLD
control messages and allow better network performance.
802.1p Priority Select a priority level (0 – 7) to which the Switch changes the priority in outgoing MLD
messages.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
