ZyXEL Communications XMG1930-30 - CHAPTER 3 Hardware Panels; 3.1 Front Panel Connections

Chapter 3 Hardware Panels
XMG1930 Series User’s Guide
45
CHAPTER 3
Hardware Panels
This chapter describes the front panel and rear panel of the Switch and shows you how to make the
hardware connections.
3.1 Front Panel Connections
The following figures show the front panels of the Switch.
Figure 12 Front Panel: XMG1930-30
Figure 13 Front Panel: XMG1930-30HP
The following table describes the ports.
Table 8 Front Panel Connections
CONNECTOR DESCRIPTION
100M, 1G, and 2.5G
RJ-45 Ethernet Ports
Port 1 – 24
These are 2.5GBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a notebook computer, a workstation, a WiFi 6 (802.11ax) router, a
WiFi 6 (802.11ax) AP (Access Point), or an Ethernet switch.
1G, 2.5G, 5G, and
10G RJ-45 Ethernet
Ports
Port 25 – 28
These are 10GBase-T auto-negotiating and auto-crossover Ethernet ports.
Connect these ports to a gaming computer, a NAS (network-attached storage), or a server.
100M, 1G, and 2.5G
RJ-45 PoE Ports
Port 1 – 20
These are 2.5GBase-T auto-negotiating and auto-crossover IEEE802.3at PoE+ 30 W ports.
Connect these ports to a PTZ (pan, tilt and zoom) camera, a WiFi 6 (802.11ax) router, a WiFi 6
(802.11ax) AP, or an Ethernet switch.
100M, 1G, and 2.5G
RJ-45 PoE Ports
Port 21 – 24
These are 2.5GBase-T auto-negotiating and auto-crossover IEEE802.3bt PoE++ 60 W ports.
Connect these ports to a PTZ (pan, tilt and zoom) camera, a WiFi 6 (802.11ax) router, a WiFi 6
(802.11ax) AP, or an Ethernet switch.
100M, 1G, 2.5G, 5G,
and 10G RJ-45 PoE
Ports
Port 25 – 28
These are 10GBase-T auto-negotiating and auto-crossover IEEE802.3bt PoE++ 60 W ports.
Connect these ports to a PTZ (pan, tilt and zoom) camera, a WiFi 6 (802.11ax) router, a WiFi 6
(802.11ax) AP, or an Ethernet switch.