Chapter 4 Web Configurator
XMG1930 Series User’s Guide
83
4.5.2 Protection
In Protection, you can set up loop guard and broadcast storm control.
In order to set up loop guard, please do the following. Click Wizard > Protection > Step 1 Loop Guard to
access this screen.
Figure 51 Wizard > Protection > Step 1 Loop Guard
Each field is described in the following table.
After clicking Next, the Broadcast Storm Control screen appears.
Previous Click Previous to show the previous screen.
Finish Review the information and click Finish to create the task.
Cancel Click Cancel to exit this screen without saving.
Table 24 Wizard > Basic > Step 4 Summary (continued)
LABEL DESCRIPTION
Table 25 Wizard > Protection > Step 1 Loop Guard
LABEL DESCRIPTION
Loop Guard
Select all ports Select all ports to enable the loop guard feature on all ports.
You can select a port by clicking it.
Next Click Next to show the next screen.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
