Chapter 7 Wireless
XMG3512-B10A User’s Guide
96
7.7 The Others Screen
Use this screen to configure advanced wireless settings. Click Network Setting > Wireless > Others. The
screen appears as shown.
See Section 7.9.2 on page 100 for detailed definitions of the terms listed in this screen.
Figure 41 Network Setting > Wireless > Others
The following table describes the labels in this screen.
Table 26 Network Setting > Wireless > Others
LABEL DESCRIPTION
RTS/CTS
Threshold
Data with its frame size larger than this value will perform the RTS (Request To Send)/CTS (Clear
To Send) handshake.
Enter a value between 0 and 2347.
Fragmentation
Threshold
This is the maximum data fragment size that can be sent. Enter a value between 256 and 2346.
Output Power Set the output power of the XMG. If there is a high density of APs in an area, decrease the
output power to reduce interference with other APs. Select one of the following: 20%, 40%,
60%, 80% or 100%.
Beacon Interval When a wirelessly networked device sends a beacon, it includes with it a beacon interval. This
specifies the time period before the device sends the beacon again.
The interval tells receiving devices on the network how long they can wait in low power mode
before waking up to handle the beacon. This value can be set from 50ms to 1000ms. A high
value helps save current consumption of the access point.
DTIM Interval Delivery Traffic Indication Message (DTIM) is the time period after which broadcast and
multicast packets are transmitted to mobile clients in the Power Saving mode. A high DTIM
value can cause clients to lose connectivity with the network. This value can be set from 1 to
255.
To Next Page
Loading...
