Chapter 24 Multicast
XS1930 Series User’s Guide
202
End Address Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the Start Address and End
Address fields.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Clear Click Clear to reset the fields to the factory defaults.
Profile Name This field displays the descriptive name of the profile.
Start Address This field displays the start of the multicast address range.
End Address This field displays the end of the multicast address range.
Delete Profile Select a profile’s check box to select a specific profile. Otherwise, select the check box in the
table heading row to select all profiles.
Delete Rule Select the check box(es) of the rule(s) that you want to remove from a profile.
Delete To delete the profile(s) and all the accompanying rules, select the profile(s) that you want to
remove in the Delete Profile column, then click the Delete button.
To delete a rule(s) from a profile, select the rule(s) that you want to remove in the Delete Rule
column, then click the Delete button.
Cancel Click Cancel to clear the Delete Profile/Delete Rule check boxes.
Table 94 Advanced Application > Multicast > IPv4 Multicast > IGMP Snooping > IGMP Filtering Profile
LABEL DESCRIPTION
To Next Page
Loading...
