XS1930 Series User’s Guide
79
CHAPTER 8
Basic Setting
8.1 Overview
This chapter describes how to configure the System Info, General Setup, Switch Setup, IP Setup, Port
Setup, PoE Setup, Interface Setup, IPv6, DNS and Cloud Management screens.
8.1.1 What You Can Do
• Use the System Info screen (Section 8.2 on page 79) to check the firmware version number and
monitor the Switch temperature, fan speeds and voltage.
• Use the General Setup screen (Section 8.3 on page 81) to configure general settings such as the
system name and time.
• Use the Switch Setup screen (Section 8.5 on page 84) to choose your VLAN type, set the GARP timers
and assign priorities to queues.
• Use the IP Setup screen (Section 8.6 on page 85) to configure the Switch IP address, default gateway
device, and the management VLAN ID.
• Use the Port Setup screen (Section 8.7 on page 89) to configure Switch port settings.
• Use the PoE Setup screens (Section 8.8 on page 90) to view the current amount of power that PDs are
receiving from the Switch and set the priority levels for the Switch in distributing power to PDs. This
screen is available for PoE model(s) only.
• Use the Interface Setup screens (Section 8.9 on page 97) to configure Switch interface type and
interface ID settings.
• Use the IPv6 screens (Section 8.10 on page 98) to view IPv6 status and IPv6 configuration.
• Use the DNS screen (Section 8.11 on page 111) to configure the default domain name server.
• Use the Cloud Management screen (Section 8.12 on page 112) to display links to Nebula Control
Center Discovery and Nebula Switch Registration screens.
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen as shown. Use this screen
to view general system information. You can check the firmware version number and monitor the Switch
temperature, fan speeds and voltage in this screen.
To Next Page
Loading...
