Chapter 8 Basic Setting
XS1930 Series User’s Guide
98
8.10 IPv6
Use this screen to view the IPv6 interface status and configure Switch’s management IPv6 addresses.
Click Basic Setting > IPv6 in the navigation panel to display the IPv6 status screen as shown next.
Figure 69 Basic Setting > IPv6
The following table describes the labels in this screen.
8.10.1 IPv6 Interface Status
Use this screen to view a specific IPv6 interface status and detailed information. Click an interface index
number in the Basic Setting > IPv6 screen. The following screen opens.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This field displays the index number of an entry.
Interface Type This field displays the type of interface.
Interface ID This field displays the identification number of the interface.
Interface This field displays the interface’s descriptive name which is generated automatically by the
Switch. The name is from a combination of the interface type and ID number.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.
Table 34 Basic Setting > Interface Setup (continued)
LABEL DESCRIPTION
Table 35 Basic Setting > IPv6
LABEL DESCRIPTION
Index This field displays the index number of an IPv6 interface. Click on an index number to view more
interface details.
Interface This is the name of the IPv6 interface you created.
Active This field displays whether the IPv6 interface is activated or not.
To Next Page
Loading...
