Chapter 13 Interfaces
ZyWALL USG 100/200 Series User’s Guide
295
• See Section 7.1 on page 115 for an example of configuring Ethernet interfaces,
port role, and zones.
• See Section 7.2 on page 120 for an example of configuring a cellular (3G)
interface.
• See Section 7.4 on page 125 for an example of setting up a wireless LAN.
• See Chapter 14 on page 367 to configure load balancing using trunks.
13.2 Port Role
To access this screen, click Configuration > Network > Interface > Port Role.
Use the Port Role screen to set the ZyWALL’s flexible ports as part of the lan1,
lan2, ext-wlan or dmz interfaces. This creates a hardware connection between
the physical ports at the layer-2 (data link, MAC address) level. This provides
wire-speed throughput but no security.
Not the following if you are configuring from a computer connected to a lan1,
lan2, ext-wlan or dmz port and change the port's role:
1 A port's IP address varies as its role changes, make sure your computer's IP
address is in the same subnet as the ZyWALL's lan1, lan2, ext-wlan or dmz IP
address.
2 Use the appropriate lan1, lan2, ext-wlan or dmz IP address to access the
ZyWALL.
Figure 266 Configuration > Network > Interface > Port Role
Physical Ports
Interfaces
To Next Page
Loading...
