EasyManuals Logo

1 BY ONE Shinny White Series User Manual

Default Icon
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Paper Thin Digital Indoor HDTV Antenna
Shinny White Series - 35 Miles Range
Model OUS00-0567
Congratulations! You have just purchased the nest, technologically advanced,
easy-to-install, HD digital antenna for indoor use. 1byone® products have been
rated “best sellers. We hope your investment in this quality antenna will give you
and your family years of enjoyment. Thank you for your purchase and your
support. We invite you to visit our website at www.1byone.com for other
high-quality products.
Package Contents -
Antenna with attached 20ft. coaxial cable
3M Adhesive Mounting Stickers
Instruction Manual
Warranty Card
www.1byone.com
Copyright ©2015 1byone Products, Inc. All rights reserved
Will the picture be better than cable?
All cable companies compress their HD signals. The result is a degraded signal that is usually inferior to
ATSC broadcast. Many factors determine whether your picture quality will be better in every instance.
However, your picture quality should greatly improve using your 1byone® ATSC compatible digital antenna.
Can I connect the antenna to multiple televisions?
No. However, the signal should only be split between multiple HDTVs if using an amplied antenna.
Troubleshooting
What if I can’t receive a signal with my 1byone® antenna?
1. Check to make sure you have correctly connected the antenna to your HDTV or third-party HD receiver.
See the Setup Guide under, “Connect the Antenna and Amplier” in this manual.
2. Re-Scan for Channels. See the Setup Guide under, “Scan for Channels” in this manual.
3. Reposition the antenna in a dierent location. Maybe higher on a wall or close to a window?
Facing the direction of the broadcast tower is usually best. Signal strength will vary based
on certain conditions. Distance from the tower, hills, buildings and even tall trees can impact
reception. Always re-scan for channels after moving the antenna.
One channel is missing.
1. Something may be obstructing the signal. Move the antenna, then re-scan for channels.
2. Try turning the antenna 10 or 20 degrees in either direction to avoid reection, then re-scan for channels.
The picture or sound freezes while I am watching a channel, or there are boxes in the picture.
This is often caused by a weak or intermittent signal. Try moving the antenna to a dierent location or
aiming it in the direction of the broadcast tower for that channel.
For Optimal Performance
Place your 1byone® antenna in the location with the strongest reception. Typically this will be on a
window and facing the broadcaster’s tower. A television signal can become weak or intermittent by trying
to pass through walls that are exceptionally thick or contain large amounts of metal. Your 1byone®
antenna can usually pick up the stronger signals from almost any direction. Experiment with dierent
walls and even dierent rooms to nd the best location to mount your antenna. To check the exact
distance from your residence to the nearest tower, go to - http://dtv.gov/maps and type in your zip
code. You will then have a better idea of what you should expect in the way of reception. If there are
multiple tower locations, optimize the position of your 1byone antenna by pointing it in the direction of
the weakest signal (usually the farthest away from you).
Distributed by
1byone® Products, Inc.
2313 E Philadelphia St, Ontario, CA 91761
www.1byone.com
®
35 mile maximum range possible. Individual experiences may vary.
尺寸:237X216mm 材质:铜板纸120g
正面背面
形式:折页

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 1 BY ONE Shinny White Series and is the answer not in the manual?

1 BY ONE Shinny White Series Specifications

General IconGeneral
Impedance75 Ohms
Reception Range50 miles
Connector TypeF Male
ColorWhite
Frequency RangeUHF 470-862MHz
VSWR<2.0
MaterialMetal

Related product manuals