1Control Solo - Verify Remote Control Copy

14
SOLO technical data sheet
Description
1Control SOLO is an electronic device that makes it
possible to use a smartphone to activate radio-controlled
automations, such as those of a gate or a garage.
SOLO can copy the remote control of an automation
and then control it by behaving like the original remote
control.
Control of an automation
SOLO can copy the remote control of an automation
and then control it by behaving like the original remote
control.
It can copy all xed code remote controls and most
rolling-code remote controls in the frequency bands
433.0 MHz to 868.0 MHz, using AM and FM.
The old low-frequency remote controls, called quartz,
are not compatible. The complete list of compatible
remote controls is available on the 1Control website or in
the full Instruction Manual.
To control an automation all you need do is to copy
a single remote control, you do not need to copy the
remote controls of all users.
SOLO communicates with your smartphone using
Bluetooth protocol LE 4. You do not need therefore to
have an Internet connection to open the gate or garage.
Operating distance
The maximum distance between SOLO and an
automation to be controlled varies according to the type
of radio control used.
Typically, this distance is between 20 and 40
metres. The maximum distance between SOLO
and a smartphone varies according to the model of
smartphone used and typically is about 15 —20 metres.
To maximize SOLO’s range it is best to place it at least
1 meter from the ground and in a place where there are
no obstacles between the user and SOLO.
Reinforced concrete walls or metal boxes can weaken or
block the SOLO signal.
Operating conditions
It is resistant to weather conditions, does not fear rain,
snow and exposure to sunlight. IP66 certied.
Security
When using SOLO for the rst time, an 8-digit numeric
PIN code must be set. This PIN must be kept secret.
PIN code holders are considered administrators of the
device. It is possible to reset the PIN by performing a
factory reset of SOLO.
The SOLO administrator can invite other users to use an
automation, without giving them the PIN code, using the
sharing features oered by the app.
The communication between SOLO and a smartphone is
protected by latest-generation security algorithms based
on public keys and end-to-end symmetric encryption
with ephemeral keys.
The communication between SOLO and an automation
uses the same security algorithms as the copied remote
control. Therefore the degree of security oered in this
communication is the same as that of the remote control.
Power supply
SOLO is supplied with pre-tted batteries and is
already on.
Batteries can be replaced once discharged. SOLO can
memorize cloned remote controls and shared accesses,
even when it has no power supply.
You can check battery charge status with the app.
Battery life varies according to the number of operations
(openings or closures) carried out:
Average
duration
4
10
20
48 months
24 months
12 months
Daily
openings