1Control Solo - Page 22

22
1Control WHY user manual
V2 or AVIDSEN remote copy procedure
TSC, TXC, TRC, HANDY, PHOENIX,
PHOX 433 104251, 104250, 104250 OLD,
104250 RED, 104257, 104350, 654250
BFT remote control copy procedure
MITTO, MITTO M, MITTO
RCB, MITTO A, TRC,
GHIBLI, MURALE, KLEIO
1. Press and keep pressed the button 1 and at the same time press 4 times the button 2 of 1Control WHY
remote. The red LED starts ashing. Release the buttons.
2. Press the button on the original remote untill the red LED become xed and then release it.
3. When the green LED ashes quickly press the 1Control WHY’s
button in which the remote control is to be stored.
4. When the green LED ashes quickly press the 1Control WHY’s button in which the remote control is to be
stored.
5. Nearby the gate/garage (within 5 meters) press the 1Control WHY copied button for 10+ seconds, the green
LED start ashing. Wait for the LED to turn o.
6. The copy is nished. Try opening the gate/garage, if it does not open, repeat the procedure from point 1. If
by repeating the procedure is still not working, probably the receiver is locked.
Manual Rolling Code
remote copy procedure
1. Press and keep pressed the button 1 and at the same time press 4 times the button 2 of 1Control WHY
remote. The red LED starts ashing. Release the buttons.
2. Press the button on the original remote for 3-4 seconds and then release it.
3. When the green LED ashes quickly press the 1Control WHY’s button in which the remote control is to be
stored.
4. On the gate/garage control unit, press the programming button or follow the instructions on your manual to
enable programming mode. Then press the 1Control WHY copied button.
5. The copy is nished. Try opening the gate/garage, if it does not open, repeat the procedure from point 1.