INS47 2
Storing Add-On
Add-On mounts in same manner as installing to base rack (3/8” Allen Wrench required.)
Two Add-Ons per location maximum for a total of four Add-Ons.
Additional Instructions
• Use caution while taking steps to install RS Add-On Holder.
• Inspect RS Add-On Holder periodically to ensure proper working conditions.
Questions or comments? Contact our support team via email at email@1up-usa.com
Warning/Disclaimer
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental,
resulting from the incorrect mounting, improper use, inadequate maintenance, or neglect of this system.
Manufactured by: 1UP USA
To Previous Page